1Mechanisms, Detailed Processes & Governing Concepts2Mechanisms, Detailed Processes & Governing Concepts3Mechanisms, Detailed Processes & Governing Concepts4Mechanisms, Detailed Processes & Governing Concepts5Mechanisms, Detailed Processes & Governing Concepts6Mechanisms, Detailed Processes & Governing Concepts7Mechanisms, Detailed Processes & Governing Concepts8Mechanisms, Detailed Processes & Governing Concepts9Mechanisms, Detailed Processes & Governing Concepts
Mechanisms, Detailed Processes & Governing Concepts
2
The question asks for the mean monthly marine deposition for Cl – over the course of Study
3
1. Look carefully at Figure 2.
4
The marine deposition of Cl– is around 950 kg/m3 except in June, at which point it is much higher.
5
Because it has only this single outlier, you can reasonably expect that the mean,
or average, monthly deposition will be only slightly higher than 950.
6
The correct answer is (G).
1 / 9Next ▶
Mechanisms, Detailed Processes & Governing Concepts
Mechanisms, Detailed Processes & Governing Concepts
The question asks if the statement The marine deposition of Na + is highest in the winter and lowest in the summer, since the winter features greater activity of volcanoes and hydrothermal vents is supported by the results of Study 2. Use POE with the reasons given in each of the answer choices.
According to Figure 3, the monthly deposition of Na + is higher between November and January than it is between June and August.
This information then supports the statement in the question that the marine deposition of Na + is highest in the winter and lowest in the summer, thus making (C) the correct answer.
◀ Previous2 / 9Next ▶
Mechanisms, Detailed Processes & Governing Concepts
Mechanisms, Detailed Processes & Governing Concepts
The question asks what level of marine deposition the researchers would have measured if the study was repeated with the sensor placed in an underwater cave in the Atlantic Ocean where there is no movement of water.
The introduction to the passage gives the following information: Ions in seawater,
such as Cl – , SO4 2– , Na + ,and Mg 2+ , are carried down to the ocean floor through a process known as marine deposition.
Therefore, in order for there to be marine deposition, ions must be carried down somewhere.
If the water does not move past the sensor
then no marine deposition will be measured at the sensor location. The correct answer is (F).
◀ Previous3 / 9Next ▶
Mechanisms, Detailed Processes & Governing Concepts
2
The question asks what happens to the annual marine deposition as the distance from the fluid motion sensor in the Atlantic Ocean decreases in Study 3. Make sure you pay careful attention to the key in Figure 4. According to Figure 4, the annual marine depositions of both ions were highest in the Arctic Ocean at the site farthest from the Atlantic Ocean.
3
The annual marine depositions of both ions decrease as the sensor gets closer to the Atlantic Ocean site.
4
The correct answer is (A).
6
The question asks which variable remained constant in Study 2. According to Figure 3, the marine deposition of SO4 2– was not studied, eliminating (F).
◀ Previous4 / 9Next ▶
Mechanisms, Detailed Processes & Governing Concepts
1
The marine deposition of Mg
2+ changed during the study
eliminate (G).
2
According to Figure 1, the movement of water during the month changed every month during the twelve-month period, eliminating (H).
3
Only the location of the study, the Atlantic Ocean, was held constant.
4
The location did not change until Study 3. The correct answer is (J).
6
The question asks which ion had the greatest marine deposition in February and least in November. Use POE. In Figures 2 and 3, only the marine deposition of Mg2+ is highest in February and lowest in November, making (B) the correct answer.
◀ Previous5 / 9Next ▶
Mechanisms, Detailed Processes & Governing Concepts
Mechanisms, Detailed Processes & Governing Concepts
The question asks what the marine deposition of Cl – at a site 1,500 km due north of the Atlantic Ocean test site in Study 3 would most likely have been.
Refer to Figure 4. For Cl – , marine deposition increases as the distance north of the Atlantic Ocean test site increases.
At the Atlantic Ocean test site, the deposition is 3,000 kg/m 3 ,
and at 2,000 km north of the Atlantic Ocean test site, the deposition is 5,000 kg/m 3 .
Therefore, the deposition at 1,500 km north would be between these two values.
The correct answer is (H).
◀ Previous6 / 9Next ▶
Mechanisms, Detailed Processes & Governing Concepts
2
The question asks how much titrant would need to be added to a sulfur dioxide solution of 120.0 mL before the solution turned blue.
3
The passage states that Once the sulfur dioxide or sodium thiosulfate is fully oxidized, any additional iodine in the solution will bind with the starch and form a complex with a deep blue color.
4
Therefore, the solution turns blue only after the iodine has reacted with all of the analyte.
6
If the amount of sulfur dioxide were increased to 120.0 mL, the amount of titrant necessary to fully oxidize the sulfur dioxide would also increase. In Experiment 1, the solution currently turns blue at 1.0 mL of titrant
so it would require more than 1.0 mL if the sulfur dioxide volume were increased. The only possible answer is (D).
◀ Previous7 / 9Next ▶
Mechanisms, Detailed Processes & Governing Concepts
Mechanisms, Detailed Processes & Governing Concepts
The question asks for a volume of titrant at which the analyte was blue in Experiment
The key in the corner of the graph says that anything graphed with a solid line is colorless, and anything graphed with a dotted line is blue.
The curve shown in this graph changes from solid to dotted at 1 mL of titrant added,
meaning that the solution at all values of titrant less than 1 mL will be colorless, and the solution at all values greater than 1 mL will be blue.
◀ Previous8 / 9Next ▶
Mechanisms, Detailed Processes & Governing Concepts
Mechanisms, Detailed Processes & Governing Concepts
Eliminate (F), (G), and (H) because they are not greater than 1 mL. The correct answer is (J).
The question asks for a volume of titrant in Experiment 2 at which the analyte was in its fully oxidized form.
In other words, the analyte is not fully oxidized until the solution turns a deep blue color.
According to Figure 2, the solution is blue (and therefore fully oxidized) above 1 mL of titrant added.
The correct answer is (D).
◀ Previous9 / 9