Curriculum
Course: ACT SCIENCE
Login

Curriculum

ACT SCIENCE

Timed Practice

0/28 Dr Dabour Hub Science Diagram and Course Material
Text lesson

McGraw-Hill 500 ACT Science Questions — Test 8

ACT Science Practice: Experimental Design, Variables and Graphs — ACT SCIENCE notes: Identify independent, dependent and controlled variables and choose the graph that fits an experiment’s data.

1Variables in an experiment · Independent variable · Dependen2Control variables
Variables in an experiment · Independent variable · Dependent variable
Variables in an experiment
Every fair experiment changes one thing and measures what happens. The passage on UVB protection tested how well sunglasses and sunscreens block ultraviolet light, and the same logic applies to any ACT experiment.
Independent variable
The
independent variable
is the factor the experimenter deliberately changes, such as the SPF of the sunscreen.
Dependent variable
dependent variable
is the factor measured as the result, such as the UVB reading on the sensor.
1 / 2Next ▶
Control variables
1

are kept the same so that only the independent variable can explain a change, for example the same sensor, the same sunlight and the same piece of glass.
2

A quick check: the dependent variable depends on the independent variable, never the other way round.
◀ Previous2 / 2
Matching the graph to the data
Matching the graph to the data
A graph puts the independent variable on the horizontal (x) axis and the dependent variable on the vertical (y) axis. To choose between answer graphs, work out the trend in the table first

then find the graph whose shape matches.
In a sunscreen test the UVB reading that reaches the sensor falls as SPF rises

because higher SPF blocks more radiation. A correct graph therefore has SPF on the x axis and a UVB line that slopes downward, probably curving as it flattens.
Trend in table Shape of graph
Dependent variable rises steadily as x rises Straight line sloping up
Dependent variable falls as x rises Line sloping down
Falls quickly then levels off Curve that flattens
No change Horizontal line
1What question was the experiment answering?2What question was the experiment answering?3What question was the experiment answering?
What question was the experiment answering?
What question was the experiment answering?
ACT writers often ask which question the students could answer using their data.
1 / 3Next ▶
What question was the experiment answering?
1

Test each choice against the independent and dependent variables.
2

The right question links exactly those two, such as how SPF affects the UVB reaching a surface.
3

Wrong choices introduce something that was not measured,
4

such as the cost of the sunscreen, the skin colour of the user or the effect on heat,
5

or ask about a variable that stayed constant.
6

Name the independent variable.
◀ Previous2 / 3Next ▶
What question was the experiment answering?
1

Name the dependent variable.
2

Choose the question that contains both and nothing extra.
3

The same method answers what the next experiment should be: change a different independent variable, such as the thickness of a lens or the colour of the glass

while keeping everything else constant.
◀ Previous3 / 3
Reading tables quickly · Reading tables quickly
Reading tables quickly
Before answering, look at the units in the column headings and at whether values are readings, averages or percentages.
Reading tables quickly
For two groups in one passage, label each table with the group number so you do not mix them.
Where a question asks for a prediction beyond the data, continue the trend in the same direction and stay within a sensible range.
Also check how many trials each value represents. A single reading is less reliable than an average of several, and a large spread between repeats suggests the measurement is uncertain. If one value sits far from the others it may be an anomaly, and you should note it rather than let it change the trend you describe.
1UVB experiments: questions and answers2UVB experiments: questions and answers3UVB experiments: questions and answers
UVB experiments: questions and answers
UVB experiments: questions and answers
UVB has wavelengths from 280 to 320 nm

it is partly absorbed by the ozone layer, and the rest can cause sunburn and skin cancer. Group 1 shielded a UVB sensor with sunglasses that claimed protection and recorded readingsGroup 2 shielded it with glass coated with sunscreens of increasing SPF.
1 / 3Next ▶
UVB experiments: questions and answers
UVB experiments: questions and answers
SPF on the x axis, UVB reading on the y axis, falling as SPF increases.
One that links SPF with the radiation blocked, not about price, brand or cancer prevention.
The amount and thickness of sunscreen spread on the glass.
The type of sunglasses.
Calculate cost divided by the reduction in UVB reading for each SPF and pick the lowest result.
Continue the trend to a value lower than for SPF 50, since the readings decrease with SPF but level off.
◀ Previous2 / 3Next ▶
UVB experiments: questions and answers
UVB experiments: questions and answers
Compare price with the reading in Table 8.1

the group found whether there was a positive, negative or no correlation,and a $200 pair cannot be given a percentage unless it is in the table.
◀ Previous3 / 3
1Evaporation experiment2Evaporation experiment3Evaporation experiment
Evaporation experiment
Evaporation experiment
Students compared water, rubbing alcohol, orange juice and liquid bleach (about 5% sodium hypochlorite and 95% water), varying the surface area and starting volume, over one week and then seven weeks.
1 / 3Next ▶
Evaporation experiment
1

Larger amounts of water correlating with higher evaporation rates: surface area, not volume, controlled the rate.
2

Student 1 and Student 2 (orange juice and bleach are similar to water).

(alcohol evaporates faster)
3

Student 3 is not supported because surface area does matter.
4

How much liquid remained for 80 mL of orange juice with 4 cm
5

2
6

exposed after one week?
◀ Previous2 / 3Next ▶
Evaporation experiment
Evaporation experiment
Read from Table 8.3

the loss is smallso most of the 80 mL remains.
A nearly flat line, as oil evaporates very slowly.
Room temperature, air flow and volume measurement errors

but not different initial volumeswhich were controlled.
◀ Previous3 / 3
1Pendulum energy and a lake’s phosphorus levels2Pendulum energy and a lake’s phosphorus levels3Pendulum energy and a lake’s phosphorus levels
Pendulum energy and a lake’s phosphorus levels
1

In a pendulum experiment the gravitational energy at the top (mgh) turns into kinetic energy at the bottom

so they are equal. Speed at the bottom does not depend on masskinetic energy is proportional to massdoubling the release height doubles the gravitational energydoubling kinetic energy multiplies speed by about 1.4. The centripetal force provided by the string, and the centripetal acceleration v2/r, do not depend on mass, and the acceleration falls when the radius increases.
2

The speed at the bottom is unchanged.
3

A 0.010 kg bob is released from 0.35 m. What is its kinetic energy at the bottom?
4

mgh = 0.010 x 9.8 x 0.35 = 0.034 J, about 0.035 J.
5

It doubles.
6

It increases by a factor of 1.4.
1 / 3Next ▶
Pendulum energy and a lake’s phosphorus levels
Pendulum energy and a lake’s phosphorus levels
No, it is independent of mass.
Lake data: oligotrophic lakes have low nutrient levels and give excellent drinking water

while eutrophic lakes have high nutrients, algal growth, cloudy water and low dissolved oxygen.
◀ Previous2 / 3Next ▶
Pendulum energy and a lake’s phosphorus levels
Pendulum energy and a lake’s phosphorus levels
Lake managers compared phosphorus levels in four areas against a target for each.
Questions ask which area never reached the target, the trophic class of a target, the effect of the 2011 flood and the 2005 agricultural runoff programme, the narrowest range, the number of years a bay met the standard,
and the difference in phosphorus concentrations in 1993.
Each is answered by reading the relevant line against the target line in the figures.
◀ Previous3 / 3
Worked examples
1

Worked example 1. Group 2 tests sunscreens of SPF 15, 30 and 50 on glass above a UVB sensor. Identify the independent and dependent variables. [2]
2

Independent: the SPF of the sunscreen. Dependent: the UVB reading on the sensor.
3

Worked example 2. Name two control variables for this experiment and explain why they matter. [2]
4

The same sensor and the same type of glass (also the same sunlight). If these changed, the sensor reading might change for a reason other than SPF.
5

Worked example 3. The UVB reading falls as SPF increases. Describe a graph that fits this. [2]
6

SPF is on the x axis and UVB reading on the y axis. The plotted line slopes downward from left to right.
Key terms
Term Meaning
Independent variable The variable deliberately changed by the experimenter.
Dependent variable The variable measured as the outcome.
Control variable A variable kept constant to keep the test fair.
Trend The overall direction in which data change.
SPF Sun protection factor, a measure of how strongly a sunscreen blocks UVB.
UVB Ultraviolet radiation of wavelength about 280 to 320 nm.
1Avoid these mistakes2Avoid these mistakes
Avoid these mistakes
1Avoid this
Putting the dependent variable on the x axisthe independent variable goes on x.
2Avoid this
Choosing a question that mentions a variable never measured.Avoid this
3Avoid this
Letting a control variable change between trials.Avoid this
1 / 2Next ▶
Avoid these mistakes
4Avoid this
Choosing a graph before reading the trend in the table.Avoid this
◀ Previous2 / 2
Accepted payment methods