Curriculum
Course: SAAT (Tahsili)
Login

Curriculum

SAAT (Tahsili)

Mathematics · Unit 1: Logic and Geometry

0/25 Dr Dabour Hub Science Diagram and Course Material

Mathematics · Unit 7: Mathematics question bank with original diagrams

0/1 Dr Dabour Hub Science Diagram and Course Material

Mathematics · Mock exams and full tests

0/1 Dr Dabour Hub Science Diagram and Course Material

Physics · Mock exams and full tests

0/1 Dr Dabour Hub Science Diagram and Course Material

Chemistry · Unit 9: Chemistry question bank with original diagrams

0/1 Dr Dabour Hub Science Diagram and Course Material

Chemistry · Mock exams and full tests

0/1 Dr Dabour Hub Science Diagram and Course Material

Biology · Unit 1: Introduction to Biology and Classification

0/20 Dr Dabour Hub Science Diagram and Course Material
Text lesson

13.2 Electric Current and Circuits

Overview of Electric Current and Circuits. This topic is covered in 2 lessons: Current, resistance and Ohm’s law; Series and parallel circuits, power and safety.

1Key ideas2Key ideas3Key ideas4Key ideas
Key ideas
Key ideas
1
Electric current is the rate of flow of charge: I = Q/t. Unit: ampere (A) = C/s.
2
Conventional current flows from the positive terminal to the negative terminal

electrons actually drift the other way.
3
A battery or cell supplies the potential difference that drives charge round a complete circuit.
1 / 4Next ▶
Key ideas
1

4
2

Resistance is the opposition to current: R = V/I. Unit: ohm (Ω).
3

5
4

Series circuit: one path. The current is the same in every component, the voltages add, and R
5

total
6

= R₁ + R₂ + …
◀ Previous2 / 4Next ▶
Key ideas
Key ideas
6
Parallel circuit: several branches. The voltage is the same across each branch, the currents add, and 1/R
= 1/R₁ + 1/R₂ + …
7
Adding resistors in series increases the total resistance

adding them in parallel decreases it below the smallest branch.
8
◀ Previous3 / 4Next ▶
Electric current as a rate of charge flow: Charge carriers crossing a wire’s cross-section, which defines current as charge per unit time.
Key ideas
Electric current as a rate of charge flow: Charge carriers crossing a wire's cross-section, which defines current as charge per unit time." loading= - Dr Khaled Dabour Academy⤢ Enlarge
Key ideas
Kirchhoff’s laws: the current entering a junction equals the current leaving it

the voltage changes around any closed loop add to zero.
◀ Previous4 / 4
1Lessons in this topic2Lessons in this topic3Lessons in this topic
Lessons in this topic
1

Current, resistance and Ohm’s law
2

— Define current, potential difference and resistance, apply Ohm’s law, and relate resistance to a wire’s dimensions and material.
3

Series and parallel circuits, power and safety
4

— Analyse series and parallel circuits, calculate electrical power and energy, and describe household electrical safety.
5

Electrical power equals current multiplied by potential difference, and can also be written as I2R or V2/R.
6

The energy a device transfers equals its power multiplied by the time for which it operates.
1 / 3Next ▶
Lessons in this topic
1

Superconductors are materials with zero resistance, although their practical uses are still limited.
2

Heat wasted in transmission wires is called lost power, and it is reduced by lowering the current.
3

Transmitting electricity at very high voltages keeps the current low

so far less power is lost in the cables.
4

A short circuit occurs when a very low-resistance path lets an extremely large current flow.
5

A fuse protects a circuit by melting and breaking it when the current becomes too large.
6

Connecting many appliances on one circuit at the same time can overload it and cause excess current.
◀ Previous2 / 3Next ▶
I-V graph comparing a fixed resistor, a filament lamp and a diode or LED, with current against potential difference.
Lessons in this topic
I-V graph comparing a fixed resistor, a filament lamp and a diode or LED, with current against potential difference." loading= - Dr Khaled Dabour Academy⤢ Enlarge
Lessons in this topic
Each circuit in a building is protected separately, and appliances are connected in parallel.
◀ Previous3 / 3
1Current
Current — the rate of flow of charge
2Ampere
Ampere — one coulomb per second
3Resistance
Resistance — opposition to the flow of charge
4Ohm's law
Ohm’s law — V = IR at constant temperature
5Series circuit
Series circuit — a circuit with a single path for current
6Parallel circuit
Parallel circuit — a circuit with more than one path
7Equivalent resistance
Equivalent resistance — the single resistance that could replace a combination
8Power
Power — the rate at which electrical energy is transferred
Circuit quantities
Quantity Symbol and unit Measured with
Current I, ampere ammeter in series
Potential difference V, volt voltmeter in parallel
Resistance R, ohm V/I
1

A straight line through the origin on a V–I graph shows an ohmic conductor.
2

A thicker wire has less resistance.
3

For two resistors in parallel, R = (R₁R₂)/(R₁ + R₂).
4

In series the largest resistor takes the largest voltage; in parallel the smallest resistor takes the largest current.
Accepted payment methods